Guide Sleeve - Without Cleat - With Lip - 3.9 mm x 5 mm Drills 0 mm Depth Stop Crestal

0 mm Depth Stop Crestal Sinus Elevation Drill Set (Counterclockwise)

Offset from Lower Shaft: 2

Place the Fabrication Insert inside the Guide Sleeve over the corresponding Guide Post and then apply gel

035” Hex Driver is used to tighten and loosen the Stylus Set Screw against one of the four flat sides of the Guide Post

Guide Sleeve - Without Cleat - With Lip - 3.9 mm x 5 mm Drills 0 mm Depth Stop CrestalThe 3. 9 mm Guide Sleeve Without Cleat With Lip is for use with printed guides only. Sleeves are designed with a lip which secures the stereolithographic printed Guide Sleeve so it will not slip through the printed guide hole. Dimensions: ID 3. 9 mm x OD 5 mm x 5. 07 mm L OD 6. 2 mm lip x . 05 mm lip thickness Pair with: 3. 9 mm Depth Stop Drill Set