VS4-10 Offset Double Bar High Clearance Rear Bumper for Marlin or Bobbed 4Runner Body Width:4Runner Note: Recommended prop shaft length

Note: Recommended prop shaft length when using a TGH-Creeper-T and TGH-FMM with our adapter plates is 83-85mm pin to pin with wide opening of skid forward

) market in Matte PETG with a bolt-on lower radiator support and snap-in light bucket inserts

The ChickenFoot features a lot of serrations and sharp edges in a triangular shape to grab every bit of earth material you can claw at

This is a Multi-piece kit designed around our body mounts

VS4-10 Offset Double Bar High Clearance Rear Bumper for Marlin or Bobbed 4Runner Body Width:4Runner Note: Recommended prop shaft lengthThis bumper is STOUT!!! 3. 2mm thick mounting tabs to handle all of the stress and beating over the length required for these bodies on the 410 platform. 100% 304 Stainless Steel tig welded Stylish and built tough for anything you can throw at it! We Recommend removing the factory plastic at the rear or trimming them down as pictured (or similar) for best fitment and aesthetics on super short bobs 1 2 Week Lead Time Build To Order